Charred framing, compromised roof, smoke-logged walls - rebuilt right.

Structural Repair After Fire in PACOIMA, California

Structural Repair After Fire in PACOIMA, California means more than patching drywall. We assess charred framing, compromised roof structure, and water damage from firefighting efforts, then rebuild to California code. If you're searching for fire structural restoration PACOIMA California near me, our team boards up same-day, documents everything for your insurer, and gets your home or commercial building back to pre-fire condition. Call (833) 929-6186.

↗
Fast online booking

Request service today

Tell us what is happening. Our local team will confirm your visit shortly.

No spam. No obligation. Just practical help.
Thanks — we'll call shortly to confirm your visit.
Dependable Fire Damage Restoration across PACOIMA, California
Careful work. Honest options.
About this service

What Structural Repair After Fire in PACOIMA, California Involves

Structural Repair After Fire in PACOIMA, California is the licensed construction phase that follows fire suppression and cleanup: removing charred structural framing, replacing compromised roof structure and melted electrical wiring, rebuilding load-bearing walls, and sealing the envelope so the building is safe to occupy again. It is not cosmetic patching. We start with an IR thermal camera and boroscope inspection camera walkthrough to find hidden char inside wall cavities and ceiling joists, then scope the rebuild around what the framing actually needs.

In PACOIMA, the most common scenario we see is a kitchen or attic fire in a 1950s-era tract home where the fire started in old wiring and spread into the roof sheathing. By the time the fire is out, you're dealing with charred framing plus water damage from firefighting efforts and the early stages of mold growth after fire suppression. That combination is why fire damage structural repair services PACOIMA CA need a contractor who understands both the fire and the water. We handle both under one scope.

  • ✓ Same-Day Board-Up
  • ✓ Code-Correct Framing
  • ✓ Odor and Soot Handled
  • ✓ Insurance Documentation
What's included

What Structural Repair After Fire Includes

Our structural repair scope covers everything from board-up to final inspection. We list what's included so you can compare it to what other contractors quote, and we tell you upfront if something falls outside the scope before work starts.

✓

Emergency Board-Up and Tarp

Doors, windows, and roof openings secured the same day, usually within 2 to 4 hours. This stops rain intrusion and protects the structure from further damage while the insurance scope is being written.

✓

Char Removal and Framing Replacement

Charred structural framing, compromised roof structure, and smoke-damaged drywall removed down to clean material. New lumber sized and nailed to California Residential Code, with the permit pulled before work starts.

✓

Water Damage Drying

Firefighting water gets into framing and insulation. We dry with air movers and dehumidifiers and confirm with moisture meter readings that lumber is below 16% before drywall goes back up. Skipping this causes mold growth after fire suppression.

✓

Electrical and Plumbing Coordination

Melted electrical wiring gets replaced by a licensed electrician, and damaged plumbing gets repaired before walls close. We coordinate both trades inside our scope so you're not scheduling them separately.

✓

Odor Treatment During Rebuild

HEPA air scrubbers, hydroxyl generators, and encapsulant sealant applied while the walls are open. This is the only time cavity odor can be treated effectively. Final ozone generator cycle before the job closes out.

✓

Permit and Inspection

We pull the permit, schedule the inspections, and walk the job with the city inspector. You get the signed-off permit at the end, which matters for resale and for your insurance file.

How it works

Our Structural Repair After Fire Process

01

Emergency Board-Up

We arrive, secure the structure, and tarp the roof. Within the first 2 hours we've stopped the building from taking on more damage and we've photographed the exterior for your claim. You get a written scope and a start date before we leave.

02

Inspection and Scope

An IICRC Fire and Smoke Restoration Technician walks the structure with an IR thermal camera and boroscope, mapping char inside wall cavities and checking roof structure for hidden heat damage. We mark every compromised member and write the rebuild scope around what the framing actually needs, not what's visible.

03

Demo and Char Removal

We remove charred structural framing, smoke-damaged drywall, and insulation down to clean material, then treat the remaining framing with char removal chemicals. Negative air machines and HEPA air scrubbers run the whole time so soot doesn't migrate into rooms the fire never touched.

04

Framing and Rebuild

New lumber goes in to California code, melted electrical wiring is replaced by a licensed electrician, and the roof structure is rebuilt and dried. We use moisture meter readings to confirm framing is below 16% before drywall goes back up. This is the phase that takes the longest, usually 2 to 5 weeks.

05

Seal, Finish, Inspect

We seal cavities with encapsulant sealant, run a final hydroxyl generator or ozone generator cycle for odor, and finish drywall, texture, and paint. Then we walk the job with the city inspector and hand you the signed-off permit. Final walkthrough happens with you in the room.

Tools & methods

Tools and Methods We Use on Structural Rebuilds

Purpose-built equipment, used by trained technicians — so the job is done accurately the first time.

IR Thermal Camera

Finds hidden char and moisture inside wall cavities and ceiling joists without opening every wall. It's how we scope the job accurately instead of guessing.

Boroscope Inspection Camera

Lets us see inside closed cavities to confirm char removal is complete before new material goes in. Essential on roof structure and wall framing inspections.

HEPA Air Scrubber

Filters soot and fine particles out of the air during demo and rebuild. Keeps smoke residue from migrating into rooms the fire never touched.

Hydroxyl Generator

Neutralizes smoke odor in occupied spaces during the rebuild. Safe to run while crews are working, unlike ozone.

Ozone Generator

Final odor treatment cycle after the rebuild is closed in. Used only in unoccupied spaces, with the space sealed and ventilated afterward.

Moisture Meter

Confirms framing is below 16% moisture before drywall goes up. The readings get logged and go into your insurance file.

Negative Air Machine

Creates negative pressure in the work zone so soot and dust don't spread into clean areas of the house during demo.

Real results

Before and after.

Kitchen Fire Rebuild in Pacoima Civic Center

Before

A kitchen fire started in the wall wiring and charred three studs and the header above the stove. The homeowner had been told the wall could be patched and painted. Smoke odor was strong throughout the first floor and the insurance scope was stalled.

After

We opened the wall, replaced the charred framing and header to code, replaced the wiring with a licensed electrician, and rebuilt the drywall and finish. The permit passed inspection on the first try. The claim closed with full documentation.

Attic Fire Roof Structure in Hansen Hills

Before

An attic fire compromised four rafters and a section of roof sheathing. From inside the house, the damage wasn't visible. The homeowner was about to close out the insurance claim when a roofer noticed sagging.

After

We inspected with an IR thermal camera, replaced the four compromised rafters and the sheathing section, and rebuilt the roof structure to code. New insulation went in and the inspection passed. The claim was reopened and approved with our documentation.

Apartment Fire Rebuild Near San Fernando Gardens

Before

A fire in one unit spread into shared attic framing and affected three units. The building owner had three separate insurance claims and no clear documentation of what was damaged where.

After

We documented structural damage unit by unit, rebuilt the shared framing, and separated the scope by unit for each claim. All three units passed inspection and tenants moved back in on a staggered schedule over 8 weeks.

Problems we solve

Problems We Solve With Fire Structural Restoration in PACOIMA

Most fire damage problems get worse the longer they sit. Here are the ones we see most often in PACOIMA and how we handle them.

Ask a pro →
01

Charred framing painted over instead of replaced

We open the cavity, remove the charred member, and replace it with new lumber sized to code. The IR thermal camera and boroscope inspection camera confirm we found all of it before the wall closes. The permit and inspection record prove the work was done right.

↗
02

Smoke odor lingering in HVAC systems

We treat the HVAC system as part of the structural scope, running HEPA air scrubbers and hydroxyl generators during the rebuild. Ducts get cleaned and the system gets a final ozone treatment cycle before we close out the job.

↗
03

Mold growth after fire suppression

We dry the framing with air movers and dehumidifiers before any new material goes in, and we log moisture meter readings to confirm lumber is below 16%. That documentation goes in your insurance file and proves the drying was done correctly.

↗
04

Insurance claim stalled on documentation

We photograph every cavity before it closes, log every moisture reading, and write the scope in Xactimate-compatible line items. That file is what gets the claim approved. We work directly with adjusters to resolve questions before they become delays.

↗
Proof you can check

Licensed, Certified, and Documented

✓
IICRC Fire and Smoke Restoration Technician (FSRT)Institute of Inspection, Cleaning and Restoration Certification
✓
IICRC Water Damage Restoration Technician (WRT)Institute of Inspection, Cleaning and Restoration Certification
✓
IICRC Applied Structural Drying (ASD)Institute of Inspection, Cleaning and Restoration Certification
✓
EPA Lead-Safe Certified FirmU.S. Environmental Protection Agency
✓
California Contractors State License Board (CSLB) LicenseCalifornia Contractors State License Board
Good questions

Frequently Asked Questions

(833) 929-6186 →

Most residential structural rebuilds in PACOIMA run $18,000 to $75,000 in 2026, with whole-house rebuilds above that. A single-room rebuild with framing and drywall typically lands $12,000 to $28,000. Cost is driven by how much framing was charred, whether the roof structure was compromised, and how much water damage from firefighting efforts needs drying. We write the scope in insurance-ready line items so you can see exactly what drives the number before work starts.

We do. Fire Damage Restoration Pacoima is a CSLB-licensed contractor based in PACOIMA, California, and we handle both the cleanup and the structural rebuild under one scope. Our technicians hold IICRC FSRT and WRT certifications. Call (833) 929-6186 and we'll schedule an inspection, usually within 24 hours for non-emergency work and same-day for board-up.

Yes, in most cases. A standard homeowner policy covers structural repair after a fire, including framing, roof, drywall, and the water damage from firefighting efforts. What matters is documentation: we photograph every cavity, log moisture readings, and write the scope in Xactimate-compatible line items your adjuster can process. We work directly with adjusters and can usually get the scope approved without you having to argue line by line.

A single-room rebuild typically takes 3 to 5 weeks. A whole-house rebuild with roof structure replacement runs 8 to 16 weeks. The timeline depends on permit turnaround with the city, how much framing was charred, and whether the electrical and plumbing systems need replacement. We give you a written schedule before demo starts and update it weekly so you know where the job stands.

Ready when you are

Get Structural Repair After Fire in PACOIMA, California Started

One call gets a board-up crew and an inspection scheduled. We're CSLB-licensed, IICRC-certified, and we document everything for your insurance claim. Call (833) 929-6186 and we'll tell you what the rebuild actually needs.

Call Now (833) 929-6186 →
Request an appointment

Get Fire Damage Restoration in PACOIMA

Call (833) 929-6186 any time, day or night. A live person answers, takes your address and gives you an arrival window. If you prefer email, send the details to info@firedamagerestorationpacoima.com and we will respond the same day. Emergencies get priority dispatch.

Request received — our team will be in touch shortly.
Tap to call(833) 929-6186